Clean slot machine installation precautions

First, the equipment must be placed on a flat working floor. Adjust the floor screws to level the table surface.

Second, pressure cardboard belt position and pressure adjustment: a groove from the groove to two belts at the same time press (with a distance of about 4cm), adjust the pulley, adjust the pressure of the required pressure wheel in the front section of the equipment so that tension can be appropriate.

Third, the sipe spacing and the adjustment of the blade tip and the roller gap: The two blades that have been ground are mounted on a small blade holder, compacted with a small pressure plate and used together with a cutter bar; the cutter bar equipped with a blade is installed Use hexagon socket bolts on the moving tool holder, do not tighten first, adjust the tool holder to the left and right to move it horizontally to the desired position on the cross beam, and then adjust the hexagon socket screw under the tool holder to move the tool rod up and down.

Fourth, the best technicians perform on-site installation and commissioning.