No. 1: Increase in Floor Gaps
Cause Analysis
After a fall in humidity, the air becomes dry, causing solid wood floors to shrink and create noticeable gaps. This is why some companies delay maintenance until spring. During winter, the risk of floor shrinkage increases, leading to more visible gaps.
Solution
It's best not to rush into repairs during autumn. Instead, wait until spring after the temperature has changed through four seasons. At that point, any cracking or warping issues are likely stabilized, making a single repair more effective and long-lasting. This approach avoids repeated fixes and saves time and effort.
Special Reminder
Autumn is the perfect time for waxing your solid wood floors. Before applying wax, make sure the floor is clean. Apply a thin, even layer of wax and then wipe it with a soft cloth until it’s smooth and shiny. Ensure good ventilation inside your home. As the weather dries out, consider using a humidifier to maintain optimal indoor humidity levels.
No. 2: Tarnished Solid Wood Furniture
Cause Analysis
Wood furniture with painted surfaces requires careful maintenance. If the paint film is damaged, it can affect both the appearance and the structural integrity of the furniture. Poor maintenance during autumn can lead to discoloration or cracking.
Solution
Keep your solid wood furniture clean by wiping it daily with a soft, dry cloth. Once every few days, use a slightly damp cloth to remove dust. For stains, avoid rubbing; instead, gently clean with warm tea. This helps preserve the finish and extend the life of the furniture.
Special Reminder
To prevent damage, place a thin layer of glue between the furniture and the floor. Also, leave a small gap (about 0.5 to 1 cm) between the furniture and the wall. Avoid placing the furniture in overly humid areas to prevent rotting.
No. 3: Cracked Door Frame
Cause Analysis
If the door frame is made from thin wood, it may crack or warp when installed directly against the wall. This is due to differences in material properties, which can cause instability and poor contact with the wall surface.
Solution
To fix a cracked door frame, apply an adhesive and then repaint it with the original color. If the wood is too thin, it's best to have a professional rework the frame to ensure durability.
Special Reminder
As autumn approaches, it's a great time to wax your wooden floors. Clean the floor first, then apply a thin, even layer of wax. Wipe it with a soft cloth until it’s smooth and shiny. Keep the house well-ventilated and consider using a humidifier as the air gets drier.
No. 4: Loose Tile Joints
Cause Analysis
Differences in thermal expansion between the base layer, bonding layer, and tiles themselves can cause cracks or bulges within 1–2 years. If you re-pave the area, the cost could be two to three times higher than the initial installation.
Solution
Remove the sand from the back of the tile and mix it with cement and adhesive. If only part of the tile is loose, avoid tapping new mortar onto the base, as this could loosen the existing tiles.
Special Reminder
Ensure the joint width is between 2–3 mm. To avoid waste, randomly select some tiles for a non-bonded test. If there are color variations or size issues, stop laying and contact the supplier for a replacement.
No. 5: Wallpaper Corners Curling
Cause Analysis
In autumn, wallpaper needs to be properly hydrated and dried naturally—not rushed like in summer. If it dries too quickly, it can lose moisture and become warped.
Solution
Remove old glue from the wallpaper, then apply white glue to the back. Wet the front and use a plastic squeegee to press it on. After drying, remove the bead. Since autumn is dry, it's important to soak the wallpaper before applying glue.
Special Reminder
If the wallpaper bubbles, use a sewing needle to puncture the bubble and release the air. Then inject a small amount of adhesive into the hole and smooth it with a squeegee. Let it dry completely.
No. 6: Risk of Glass Shattering in the Shower
Cause Analysis
Shower room glass is often enclosed, so heat and pressure can build up, causing uneven heating and potentially leading to shattering.
Solution
Apply a high-quality safety film to the glass. This strengthens the glass significantly and holds the shards together if it breaks, preventing injuries from flying glass.
Special Reminder
Tempered glass is strong but vulnerable to sharp impacts. Be cautious around fixed shower enclosures and walls, as collisions can cause the glass to shatter entirely. Always handle with care.
Our Height Adjustable Standing Desks are high-end desk with a modern and concise appearance, ergonomic design principle, equipped with a quiet internal drive motor and a sensor controlled .The Sit Stand Desk also has an anti-collision stop function ensures safety by preventing the desktop from being damaged or crushing other objects and devices while in motion. Electric Standing Desk can be placed in your high-end office, it is more suitable for you than any desk, so that your office environment is more advanced, and employees work healthier.
Sit Stand Desk,Sit Stand Computer Desk,Sit Stand Single Motor Desk,Height Adjustable Electric Standing Desk
CHEX Electric Standing Desk , https://www.qxhdesk.com