How to do the problem of autumn furniture, how to do six tricks to eliminate troubles

No. 1: Increase in Floor Gaps

Cause Analysis

After a fall in humidity, especially during the dry season, solid wood floors tend to shrink due to the reduced moisture in the air. This shrinkage can lead to noticeable gaps between the floorboards. Some companies suggest delaying maintenance until spring, as the seasonal temperature and humidity changes can affect the stability of the flooring. In winter, the risk of further shrinkage is higher.

Solution

To address this issue, it's best to wait until spring after several seasons of temperature fluctuations. Once the floor has stabilized and no longer shows signs of cracking or warping, you can perform a single, thorough repair. This approach minimizes the need for repeated fixes and ensures long-term results.

Special Reminder:

As autumn approaches, it's the perfect time to wax your solid wood floors. Clean the floor thoroughly before applying wax, then spread a thin, even layer. After a few minutes, wipe it off with a soft cloth to make it smooth and shiny. Ensure good ventilation inside the house, and consider using a humidifier when the air becomes too dry to maintain proper indoor humidity levels.

No. 2: Tarnished Solid Wood Furniture

Cause Analysis

The surface of solid wood furniture is often coated with paint, which requires regular care. If the paint film gets damaged, it not only affects the appearance but can also compromise the structural integrity of the furniture. Poor maintenance during autumn, such as improper cleaning or exposure to dry conditions, can cause the finish to tarnish or crack.

Solution

Maintain cleanliness by wiping the furniture daily with a soft, dry cloth. Every two or three days, use a slightly damp cloth to gently clean the surface. For stains, avoid rubbing; instead, use warm tea to gently lift the stain. Always handle the furniture with care to prevent damage to the finish.

Special Reminder:

To protect your solid wood furniture, place a thin layer of glue under the legs to keep it away from the ground. Also, leave a small gap (about 0.5 to 1 cm) between the furniture and the wall to allow for airflow and prevent moisture buildup that could lead to rot.

No. 3: Cracked Door Frame

Cause Analysis

If thin wood strips are used to install the door cover directly, they may not adhere well to the wall due to differences in material properties. Thin wood lines are more prone to cracking and deforming when pressed against the wall, leading to visible cracks over time.

Solution

To fix a cracked door frame, fill the gap with an appropriate adhesive and then repaint it with the same color as the original door. If the wood is too thin, it’s better to have a professional rework the door cover to ensure durability and stability.

Special Reminder:

Autumn is a great time for floor maintenance. Before waxing, make sure the floor is clean. Apply a thin, even layer of wax, then wipe it with a soft cloth until it shines. Keep the room well-ventilated and use a humidifier if the air becomes too dry.

No. 4: Broken Seamless Tiles

Cause Analysis

Different thermal expansion coefficients among the base layer, bonding layer, and tile itself can lead to problems like bulging or breaking within 1 to 2 years. Over-tight installation increases the risk of tile failure. Replacing large areas later can be significantly more expensive than the initial installation.

Solution

Remove any sand from the back of the tile and mix it with cement and adhesive. Be careful not to tap the mortar onto the base layer if only part of the tile is loose, as this could damage the existing tiles.

Special Reminder:

Ensure the gap between tiles is between 2 to 3 mm. Before laying, randomly test some tiles on the ground without bonding to check for color inconsistencies or size deviations. If issues are found, stop the process and contact the supplier for a replacement.

No. 5: Wallpaper Corners Curling

Cause Analysis

In autumn, wallpaper needs to be properly hydrated and dried naturally—not in the summer. If freshly applied wallpaper dries too quickly due to wind, it can lose moisture and become distorted.

Solution

Remove old glue from the wallpaper, apply white glue to the back, and lightly wet the front. Use a plastic squeegee to press it onto the wall. Let it dry, then remove the bead. Make sure to soak the wallpaper in water before applying glue, especially in dry autumn conditions.

Special Reminder:

If your wallpaper starts blistering, use a sewing needle to puncture the bubbles and release the trapped air. Then, inject a small amount of adhesive into the hole and press it down with a squeegee. Allow it to dry completely for a secure finish.

No. 6: Risk of Glass Shattering in Shower Room

Cause Analysis

Shower rooms with glass enclosures are enclosed spaces where high heat and pressure can build up. This uneven heating can cause the glass to shatter unexpectedly, posing a safety hazard.

Solution

Apply a high-quality transparent safety film to the glass. This film can increase the glass strength by over six times. Even if the glass breaks, the film will hold the fragments together, preventing injury from flying shards.

Special Reminder:

Although tempered glass is strong, it is more sensitive to sharp objects than regular glass. Avoid placing heavy items near the glass or allowing anything sharp to come into contact with it. A direct impact can cause the entire panel to shatter, so always be cautious around glass shower enclosures.

Adjustable Computer Table

Whether it's renting or our own house, our indoor use area is always limited, each place has its own specific purpose, there is no extra space to put anything. However, for the convenience of life, we always need to be equipped with all kinds of equipment. For example, adults need a desk, children need a learning desk, but too many tables at home will be very crowded. If you have a Sit Stand Desk , you can perfectly solve this problem, that is, the Adjustable Standing Desk.

Height Adjustable Table can be raised and lowered to meet the needs of different heights. In addition, the Height Adjustable Standing Desks have four height memory keys, which correspond to four requirements and can be adjusted to the appropriate position with one key.

computer table


Adjustable Computer Table,Dual Motor Electric Standing Table,Sit-Stand Computer Table,Computer Table Adjustable Desk

CHEX Electric Standing Desk , https://www.qxhdesk.com

Posted on