1. When starting up, only one person can operate. When the machine is started, there will be an alarm, and all personnel should be in a safe place.
2. Each time the upper and lower plates are pushed into the machine, they must be checked for foreign objects to ensure that the plate screws are tightened. Push the board lightly so as not to damage the machine.
3. When pulling up and down, the pulley and bayonet must be in place to prevent falling and hurting people.
4. Push the paper when adjusting the side alignment and rear alignment. Do not allow too much thrust to avoid damage to the machine parts.
5. When the machine is shut down for a long time, the upper and lower plates must be pulled out of the machine to stop the lower platform at the lowest position.
6. Run the machine for 3 to 5 minutes before starting up normally, and check whether the oil pressure and air pressure are normal.
7. Before inserting the crank, you must wait until the flywheel stops completely. When manually cranking, the cranking person should stand on the side of the cranking handle. The turning direction should be reverse.
8. When ascending the take-up table, you must concentrate your thoughts to prevent the paper stool or the pile of paper on the paper stool from hitting the paper stacker, and then damaging Other components, such as the tooth row and so on. When ascending the feeding table, it is necessary to prevent the stack of paper stools from exceeding the limit and hitting Feida's head.
9. When lowering the paper conveying table and the paper receiving table, prevent your feet from being crushed.
10. When drawing proofs, pay attention to the gestures to prevent the hands from being raised too high and being injured by the teeth row.
11. Attention should be paid to hot stamping: when hot stamping the first (last) sheet, the machine will suspend the alarm and start to increase (decrease) the pressure at the same time, and will continue to run after the increase (decrease) of the pressure. When suspended, the operator pays attention to safety.
12. When collecting paper without stopping the machine, pay attention to the time not too long, because the non-stop collecting board does not automatically fall, and the thickness of the collected paper will cause the machine to stop automatically or damage the machine.
13. When entering the machine to work, be sure to stop Xiaping Tai at the lowest position and stop the main motor. After the flywheel does not convey at all, you can carry out maintenance or install anodized aluminum, otherwise it is not safe.
Shenzhen Apex Artcrafts Co,.LTD , https://www.apexdisplaycn.com