IVONDING is a kind of MID (Molded Interconnect Device) loop molding technology, which can make loops on plastic products that cannot be directly plated with gold. The sales and technical services related to IVONDING were jointly conducted by Polyplastics and Japan and the Asia Pacific General Agents Vacuum Chemicals Co., Ltd.
[1] Technical Solution Using IVOTAPE (Special Metal Thin Films) to Produce a Circuit Since an IVOTAPE (special metal thin film) can be used to directly generate a circuit on a plastic product, there is no need to use an integrated circuit board.
IVOTAPE (special metal film) can pass current from the signal to 14 amps.
[2] About IVOTAPE (Special Metal Film)
IVOTAPE is an electrolytic copper sheet with cut-through and electrical conductivity.
1. It has the same resistance as the copper bus that is commonly used in circuit boards.
2. Select the desired metal thickness from the four metal thicknesses of 18, 35, 70, and 100 microns.
3. According to different purposes, tin, lead, nickel, silver and gold can be plated on the surface of copper moorings.
4. The projections attached to the back of the IVOTAPE are tightly bonded to the plastic after being inserted into the plastic, and almost no aging occurs even under long-term use and high temperature conditions.
[3] Features of processing and manufacturing 1. As the products can be directly processed, the design of the products is very wide. Not only in the plane, but also in the slope and the side of the loop.
2. The processed product loop can pass the signal current to 14 ampere current.
3. The wide choice of materials for the products does not require the use of gold-plated products.
4. Because of its short production cycle and low investment, the production cost is low.
5. Because the manufacturing process is simple, the manufacturer can complete all the processes from the product to the circuit independently.
6. In the manufacturing process, there is no need to use chemical products at all, and waste acid and liquid waste are not used to treat the environment. This is a non-liquid production project.
[1] Technical Solution Using IVOTAPE (Special Metal Thin Films) to Produce a Circuit Since an IVOTAPE (special metal thin film) can be used to directly generate a circuit on a plastic product, there is no need to use an integrated circuit board.
IVOTAPE (special metal film) can pass current from the signal to 14 amps.
[2] About IVOTAPE (Special Metal Film)
IVOTAPE is an electrolytic copper sheet with cut-through and electrical conductivity.
1. It has the same resistance as the copper bus that is commonly used in circuit boards.
2. Select the desired metal thickness from the four metal thicknesses of 18, 35, 70, and 100 microns.
3. According to different purposes, tin, lead, nickel, silver and gold can be plated on the surface of copper moorings.
4. The projections attached to the back of the IVOTAPE are tightly bonded to the plastic after being inserted into the plastic, and almost no aging occurs even under long-term use and high temperature conditions.
[3] Features of processing and manufacturing 1. As the products can be directly processed, the design of the products is very wide. Not only in the plane, but also in the slope and the side of the loop.
2. The processed product loop can pass the signal current to 14 ampere current.
3. The wide choice of materials for the products does not require the use of gold-plated products.
4. Because of its short production cycle and low investment, the production cost is low.
5. Because the manufacturing process is simple, the manufacturer can complete all the processes from the product to the circuit independently.
6. In the manufacturing process, there is no need to use chemical products at all, and waste acid and liquid waste are not used to treat the environment. This is a non-liquid production project.
Dongxing Aluminum Co., Ltd. , http://www.hljaluminumfoil.com